No studio building project is alike. In a joint meeting we clarify terms and requirements, develop an individual project plan and cost schedule and guide the project till the final step. Our team at work: Zeke Lund is connecting microphone tie lines. Final checking of a routing matrix (Tuchel Format 32 to 64)   We get it right if it doesn´t fit. Depiction of a 7-part Lemo-coaxial-patchcords for analog and digital usage with Push`n Pull lock.   Backview of a custom-built 19 inch panel (2x sub-D 25, 2x XLR, 9x BNC, 1x DL60)   Double-shielded Alcatel control cable Due 4512 already crimped and ready to get assembled to a Sub-D 25 plug.   The assembling of a BNC Push `n Pull Patchcord (plug: Neutrik Push & Pull, cabel: double shielded Belden 1505a) with the necessary crimpimg tool. We usually take care of following tasks: Studio planning Selection and procurement of studio equipment Planning of acoustics Power supply and electrics Air conditioning Carpentry Custom manufacture (racks, panels, headphoneboxes, etc.) Wiring System check Set-up (e.g. Pro-Tools, SSL, etc.) Introduction and training We cover: post-production/mastering, music recording, voice-over, and club sound systems.